Telnet Server Acl - HPE D6020 Maintenance And Service Manual

Views
User view
Predefined user roles
network-admin
Parameters
remote-host: Specifies the IPv6 address or host name of a remote host. A host name can be a
case-insensitive string of 1 to 253 characters. Valid characters include letters, digits, hyphens (-),
underscores (_), and dots (.).
-i interface-type interface-number: Specifies the interface for sending Telnet packets. This option is
required when the remote host address is a link-local address. When the server address is a global
unicast address, you cannot specify this option.
port-number: Specifies the TCP port number for the Telnet service on the remote host. The value
range is 0 to 65535 and the default is 23.
vpn-instance vpn-instance-name: Specifies the VPN instance to which the remote host belongs,
where vpn-instance-name is a case-sensitive string of 1 to 31 characters. If the remote host belongs
to the public network, do not specify this option.
source: Specifies a source IPv6 address or source interface for outgoing Telnet packets. If you do
not specify this option, the device uses the primary IPv6 address of the output interface for the route
to the server as the source address.
interface interface-type interface-number: Specifies the source interface. The primary IPv6 address
of the interface will be used as the source IPv6 address for outgoing Telnet packets.
ipv6 ipv6-address: Specifies the source IPv6 address for outgoing Telnet packets.
dscp dscp-value: Specifies a DSCP value for outgoing Telnet packets. The value range is 0 to 63.
The default is 48.
Usage guidelines
This command is not supported in FIPS mode.
To terminate the current Telnet connection, press Ctrl+K or execute the quit command.
Examples
# Telnet to the host at 5000::1.
<Sysname> telnet ipv6 5000::1
# Telnet to the host at 2000::1. Use 1000::1 as the source address for outgoing Telnet packets.
<Sysname> telnet ipv6 2000::1 source ipv6 1000::1

telnet server acl

Use telnet server acl to apply an ACL to filter Telnet logins.
Use undo telnet server acl to restore the default.
Syntax
telnet server acl [ mac ] acl-number
undo telnet server acl
Default
No ACL is used to filter Telnet logins.
Views
System view
94