Free Line - HPE D6020 Maintenance And Service Manual

Views
User line view
Predefined user roles
network-admin
Parameters
hardware: Performs hardware flow control.
none: Disables flow control.
software: Performs software flow control.
direction1, direction2: Specify the software flow control direction and hardware flow control direction.
•
in: Listens to flow control information from the remote device.
•
out: Sends flow control information to the remote device.
Usage guidelines
This command is not supported in VTY line view.
The device can perform flow control in either or both of the inbound and outbound directions. One
direction supports one flow control mode.
To specify the same flow control mode for the two directions, use the flow-control { hardware |
software | none } command.
To specify different flow control modes for the two directions, use the flow-control hardware
direction1 [ software direction2 ] or flow-control software direction1 [ hardware direction2 ]
command. If you do not specify the software direction2 or hardware direction2 option, the flow
control mode none applies to the direction represented by the option.
For two devices to communicate, make sure their flow control modes match.
Examples
# Configure hardware flow control in the inbound direction and disable flow control in the outbound
direction for console line 0.
<Sysname> system-view
[Sysname] line console 0
[Sysname-line-console0] flow-control hardware in
# Configure hardware flow control in the inbound direction and software flow control in the outbound
direction for console line 0.
<Sysname> system-view
[Sysname] line console 0
[Sysname-line-console0] flow-control hardware in software out

free line

Use free line to release a user line.
Syntax
free line { number1 | { aux | console | tty | vty } number2 }
Views
User view
Predefined user roles
network-admin
64