Sha256Sum - HPE D6020 Maintenance And Service Manual

Predefined user roles
network-admin
Parameters
interface interface-type interface-number: Specifies the source interface used to synchronize files
and directories from an Rsync server. After you specify the source interface, the device uses the
primary IPv4 address of the source interface as the source IP address for outgoing packets. For
success file transfer, make sure the source interface has a primary IP address and is in up state.
ip source-ip: Specifies the source IP address for outgoing packets. The source IP address must
have been configured on the device.
Usage guidelines
The following matrix shows the command and hardware compatibility:
Hardware
MSR954 (JH296A/JH297A/JH298A/JH299A/JH373A)
MSR958 (JH300A/JH301A)
MSR1002-4/1003-8S
MSR2003
MSR2004-24/2004-48
MSR3012/3024/3044/3064
MSR4060/4080
If you execute this command multiple times, the most recent configuration takes effect.
The source IP address specified in this command applies to all synchronization operations. The
source IP address specified in the rsync command applies only to the current synchronization
operation. The source IP address specified in the rsync command takes precedence over the
source IP address specified in this command.
Examples
# Set the source IP address used for file and directory synchronization to 1.1.1.1.
<Sysname> system-view
[Sysname] rsync client source ip 1.1.1.1
Related commands
rsync

sha256sum

Use sha256sum to use the SHA-256 algorithm to calculate the digest of a file.
Syntax
sha256sum file
Views
User view
Predefined user roles
network-admin
Command compatibility
Yes
Yes
No
No
No
No
No
173