Telnet Client Source; Telnet Ipv6 - HPE D6020 Maintenance And Service Manual

Examples
# Telnet to host 1.1.1.2, using 1.1.1.1 as the source IP address for outgoing Telnet packets.
<Sysname> telnet 1.1.1.2 source ip 1.1.1.1
Related commands

telnet client source

telnet client source
Use telnet client source to specify a source IPv4 address or source interface for the Telnet client to
use for outgoing Telnet packets.
Use undo telnet client source to restore the default.
Syntax
telnet client source { interface interface-type interface-number | ip ip-address }
undo telnet client source
Default
No source IPv4 address or source interface is specified. The Telnet client uses the primary IPv4
address of the output interface for the route to the server as the source IPv4 address.
Views
System view
Predefined user roles
network-admin
Parameters
interface interface-type interface-number: Specifies a source interface. The primary IPv4 address of
the interface will be used as the source IPv4 address for outgoing Telnet packets.
ip ip-address: Specifies a source IPv4 address.
Usage guidelines
This command is not supported in FIPS mode.
The setting configured by this command applies to all Telnet connections but has a lower
precedence than the source setting specified for the telnet command.
Examples
# Set the source IPv4 address to 1.1.1.1 for outgoing Telnet packets.
<Sysname> system-view
[Sysname] telnet client source ip 1.1.1.1
Related commands
display telnet client configuration

telnet ipv6

Use telnet ipv6 to Telnet to a host in an IPv6 network.
Syntax
telnet ipv6 remote-host [ -i interface-type interface-number ] [ port-number ] [ vpn-instance
vpn-instance-name ] [ source { interface interface-type interface-number | ipv6 ipv6-address } ]
[ dscp dscp-value ]
93