Shutdown-Interval - HPE D6020 Maintenance And Service Manual

To configure a schedule:
1. Use the scheduler job command to create a job and enter job view.
2. Use the command command to assign commands to the job.
3. Use the scheduler schedule command to create a schedule and enter schedule view.
4. Use the job command to assign the job to the schedule. You can assign multiple jobs to a
schedule. The jobs must already exist.
5. Use the user-role command to assign user roles to the schedule. You can assign up to 64 user
roles to a schedule.
6. Use the time at, time once, or time repeating command to specify an execution time for the
schedule. You can specify only one execution time for a schedule.
Examples
# Create a schedule named saveconfig.
<Sysname> system-view
[Sysname] scheduler schedule saveconfig
Related commands
job
time at
time once

shutdown-interval

Use shutdown-interval to set the port status detection timer.
Use undo shutdown-interval to restore the default.
Syntax
shutdown-interval interval
undo shutdown-interval
Default
The port status detection timer setting is 30 seconds.
Views
System view
Predefined user roles
network-admin
Parameters
interval: Specifies the port status detection timer value in seconds. The value range is 0 to 300. To
disable port status detection, set this argument to 0.
Usage guidelines
The device starts a port status detection timer when a port is shut down by a protocol. Once the timer
expires, the device brings up the port so the port status reflects the port's physical status.
If you change the timer setting during port detection, the device compares the new setting (T1) with
the time that elapsed since the port was shut down (T).
•
If T < T1, the port will be brought up after T1 – T seconds.
• If T ≥ T1, the port is brought up immediately.
345