Installing And Removing An Sd Memory Card - Mitsubishi Electric Q26UD(E)HCPU User Manual

4.6

Installing and Removing an SD Memory Card

This section describes a procedure for installing and removing an SD memory card.
(1) Installing an SD memory card
Pay attention to the direction of an SD memory card and install the card according to the following procedure.
1.
Insert an SD memory card straight into the SD memory card slot.
The notch part of the SD memory card must be on the lower side.
After installing the SD memory card, check that it is inserted completely. Poor contact may cause
malfunction.
2.
The SD CARD LED starts flashing, and turns on when the card is ready to be used.
3.
Check that the SD CARD LED remains on.
If the SD CARD LED does not turn on even after an SD memory card is installed, check that SM606 (SD memory card
forced disable instruction) and SM607 (SD memory card forced disable status flag) are off.
Basic
Note 4.2
performance
The Basic model QCPU, High Performance model QCPU, Process CPU, and Redundant CPU do not support the use of
SD memory cards. For the Universal model QCPU, only the QnUDVCPU supports the use of SD memory cards.
High
Process
Redundant Universal
CHAPTER 4 INSTALLATION AND WIRING
Note 4.2
Note 4.2
4
99