Mitsubishi Electric Q26UD(E)HCPU User Manual page 578

(17)iQ Sensor Solution
Number Name
Use request (iQ
SD1435 Sensor Solution
backup/restoration)
Right acquisition
status (iQ Sensor
SD1436
Solution
backup/restoration)
Target
module/execution
SD1437 unit setting (iQ
Sensor Solution
backup/restoration)
Folder number
setting (iQ Sensor
SD1438
Solution
backup/restoration)
Target module
setting (iQ Sensor
SD1439
Solution
backup/restoration)
Target device 1
setting (iQ Sensor
SD1440
Solution
backup/restoration)
576
Meaning
This register is used to acquire a right to use the
backup/restoration function before its execution.
A four-digit number (other than request number
0000 ) shall be set.
H
The number is determined according to the
Requests the use
request source.
of the
1*** : when requested using a ladder program
backup/restoration
H
D*** : when requested from MELSOFT
function.
H
Navigator
E*** : when requested from GOT
H
F*** : when requested from GX Works2
H
• A value is cleared to "0" when the right is lost.
Stores the request
source that has This register stores the request source that has
acquired a right to acquired a right to use the backup/restoration
use the function.
backup/restoration • A value is cleared to "0" when the right is lost.
function.
This register is used to set the target module
and execution unit for backup/restoration.
Lower 8 bits (target module)
1 : AnyWireASLINK
H
2 : CC-Link
H
3 : Ethernet
H
4 : CC-Link IE Field Network
H
Upper 8 bits (execution unit)
Sets the target
[AnyWireASLINK]
module and
1 : Module
execution unit for
H
2 : ID
backup/restoration.
H
[CC-Link, CC-Link IE Field Network]
1 : Module
H
2 : Station
H
3 : Station sub-ID
H
[Ethernet]
1 : Module
H
2 : IP address
H
This register is used to set a number of a folder
in which backup data is to be stored or a folder
that contains data for restoration.
Sets the folder
0 to 99: Folder number specification
number for
FFFE : Automatic specification (folder deletion
backup/restoration.
H
supported)
FFFF (default): Automatic specification
H
This register is used to set a module targeted for
backup/restoration.
Sets a module
I/O No.: Module (Enter the value obtained by
targeted for
dividing the start I/O number by 16.)
backup/restoration.
3FF : Built-in Ethernet
H
This register is used to set a device targeted for
backup/restoration.
[AnyWireASLINK]
ID number
[CC-Link, CC-Link IE Field Network]
Sets devices
Station number
targeted for
[Ethernet]
backup/restoration.
IP address (lower 16 bits)
(Example) If the IP address is 192.168.3.40, 3
equals to 3
H
The stored value will be 0328
Explanation
and 40 equals to 28 .
H
, that is, 808.
H
Corresponding
Set by
ACPU
(When Set)
D9
S (Status
New
change)/U
S (Status
New
change)
U New
U New
U New
U New
Corresponding
CPU
*1
QnUDV
*2
LCPU
*1
QnUDV
*2
LCPU
*1
QnUDV
*2
LCPU
*1
QnUDV
*2
LCPU
*1
QnUDV
*2
LCPU
*1
QnUDV
*2
LCPU