Mitsubishi Electric Q26UD(E)HCPU User Manual page 351

Error
Error and cause
code
[LOAD ERROR]
• After auto loading, the memory size exceeds the
capacity of the CPU module or SD memory
card.
• After auto loading, the number of stored files
exceeds the number of files that can be stored
2247
in the CPU module or SD memory card.
■Collateral information
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset
[LOAD ERROR]
Auto loading was executed to a write-protected SD
memory card.
■Collateral information
2248
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset
[INIT.TIME OVER]
Since an initial processing takes time, the host
CPU module cannot respond to communication
requests from other CPU modules in initial
communications at a system configuration of a
multiple CPU system and other CPU modules
2290
cannot be started up.
■Collateral information
• Common information: -
• Individual information: -
■Diagnostic timing
• At power-on/At reset
[ICM. OPE. ERROR]
• A memory card was removed without turning on
SM609 (Memory card remove/insert enable
flag).
• A memory card was removed while SM600
(Memory card usable flags) is on.
■Collateral information
• Common information: Drive Name
• Individual information: -
■Diagnostic timing
2300
• When memory card is inserted or removed
[ICM. OPE. ERROR]
An SD memory card was removed without the
card being disabled.
■Collateral information
• Common information: Drive Name
• Individual information: -
■Diagnostic timing
• When SD memory card is inserted or removed
Corrective action
• Check the size of load-target data so that it
will not be larger than the memory capacity,
and execute auto loading.
• Check the number of files so that it will not
exceed the number of storable files, and
execute auto loading.
Cancel the write protection and execute the
auto loading.
Shorten the initial processing time.
• Check the restoration setting or reconsider
the number of files to be restored if the
automatic restoration function of CPU
module is executed.
• Turn on SM609 (Memory card
remove/insert enable flag) and then
remove the memory card.
• Check that SM600 (Memory card usable
flags) is off and then remove the memory
card.
Disable the card, and then remove it.
APPENDICES
LED status, Corresponding
CPU status CPU
RUN: Off
ERR.:Flashing
LCPU
CPU Status:Stop
RUN: Off
ERR.:Flashing
LCPU
CPU Status:Stop
RUN: Off
ERR.:Flashing
QnUDV
CPU Status:Stop
Qn(H)
QnPH
QnPRH
QnU (except
RUN: Off/On
QnUDV)
ERR.:Flashing/On
CPU Status:
*1
Stop/Continue
QnUDV
LCPU
A
349