Mitsubishi Electric Q26UD(E)HCPU User Manual page 203

Item
Mounting position
Applicable base unit
Input power supply
Input frequency
Input voltage distortion
factor
Max. input apparent
power
*1
Inrush current
5VDC
Rated output
current
24VDC
Overcurrent 5VDC
*1
protection 24VDC
5VDC
Overvoltage
*1
protection
24VDC
Efficiency
Allowable momentary
*1
power failure time
Dielectric withstand
voltage
Insulation resistance
• By noise simulator of 1500Vp-p noise voltage, 1µs noise width and 25 to 60Hz noise frequency
Noise durability
• Noise voltage IEC 61000-4-4, 2KV
Operation indication
Fuse
Application
Rated switching
voltage, current
Minimum
switching load
Response time
Life
Surge
suppressor
Fuse
Terminal screw size
Applicable wire size
Applicable solderless
RAV1.25 - 3.5, RAV2 - 3.5, thickness 0.8mm or less. Two solderless terminals can be connected to one terminal.
terminal
Applicable tightening
torque
Within 5% (
2300VAC per minute (altitude 0 to 2000m)
Between the combined "line input/LG terminals" and the "FG terminal and output"
10MΩ or higher by 500VDC insulation resistance tester
Between the combined "line input/LG terminals" and the "FG terminal and output", the line input and
LG terminals, the output and FG terminals
LED indication (Normal: On (green), Error: Off)
ERR. contact (
OFF to ON: 10ms max. ON to OFF: 12ms max.
Mechanical : More than 20 million times
Electrical : More than 100 thousand times at rated switching voltage, current
Performance Specifications
Q61SP
Power supply module mounting slot
Q3SB
+10%
100 to 240VAC
-15%
(85 to 264VAC)
50/60Hz ±5%
Page 103, Section 4.8.1)
40VA
40A within 8ms
2A
----
2.2A or more
----
5.5 to 6.5V
----
70% or more
Within 20ms (AC100VAC or more)
Built-in (User-unchangeable)
Page 188, Section 7.1)
24VDC, 0.5A
5VDC, 1mA
None
None
M3.5 screw
2
0.75 to 2mm
0.66 to 0.89N•m
CHAPTER 7 POWER SUPPLY MODULE
7
201