Mitsubishi Electric Q26UD(E)HCPU User Manual page 666

3) Ferrite core and cable clamp types
• Cable clamp
Type: AD75CK (Mitsubishi)
• Ferrite core
Type: ZCAT3035-1330 (TDK ferrite core)
Cable length
Within 2m
2m to 10m
4) Cable clamp mounting position
Refer to
(c) I/O signal lines
Ground the shield section of an I/O signal cable (including common line) in the same way as explained in Page
655, Appendix 8.1.3 (1) when it is extended out of the control panel.
(d) Extension cable
Ground the shield section of an extension cable in the same way as explained in Page 655, Appendix 8.1.3 (1)
when it is extended out of the control panel.
(2) Power supply module
The following table lists the precautions required for each power supply module. Always observe the items noted
as precautions.
A1S61P, A1S62P, A61P, A62P
*1
A1S63P , A163P
A1S61PEU, A1S62PEU, A1S61PN, A1S62PN,
A61PN, A61PEU, A62PEU, A68P
*1 Installing a filter to a power line is not required if the version of the A1S63P is F or later.
Make sure to use the CE-marked 24VDC panel power equipment.
664
AD75CK
AD75CK
ZCAT3035-1330
Page 656, Appendix 8.1.3 (2).
Model
Prepared part
Not usable
Use the CE marked 24VDC panel power equipment.
Always ground the LG and FG terminals after short-circuiting them.
Number of ferrite cores
1 axis 2 axes
1 1
1 1
1 2
Precautions
3 axes
1
1
3