Wiring To Connectors - Mitsubishi Electric Q26UD(E)HCPU User Manual

4.8.3

Wiring to connectors

(1) Precautions
• Connectors for external devices (A6CON) must be crimped, pressed, or correctly soldered.
• Plug connectors for external devices (A6CON) securely to the module and tighten the two screws.
• Use copper wires having temperature rating of 75°C or more for the connectors.
• Tighten the connector screws within the following specified torque range.
Connector screw (M2.6)
• Place the cables in a duct or clamp them. If not, dangling cable may swing or inadvertently be pulled,
resulting in damage to the module or cables or malfunction due to poor connection.
To make the wiring comply with the EMC and Low Voltage Directives, refer to Page 651, Appendix 8.
Even when compliance with the EMC Directive and Low Voltage Directives is not required, configuring the system that
complies with the EMC Directive may reduce external noise.
(2) Applicable connectors
The following tables list the crimp tool, pressure-displacement tools, and the types of connectors used for
modules.
(a) 40-pin connector
Soldering connector
(straight out type)
Crimp connector
(straight out type)
Pressure-displacement connector
(straight out type)
Soldering connector
(both for straight out and 45-degree types)
(b) Crimp tool and pressure-displacement tools for 40-pin connectors
Type
Crimp tool
Pressure-
displacement
tool
For wiring of the connectors and usage of the crimp tool and pressure-displacement tools, contact FUJITSU
COMPONENT LIMITED.
Screw type
Type
A6CON1
A6CON2
A6CON3
A6CON4
Model
FCN-363T-T005/H
FCN-367T-T012/H (locator plate)
FCN-707T-T001/H (cable cutter)
FCN-707T-T101/H (hand press)
CHAPTER 4 INSTALLATION AND WIRING
Tightening torque range
•
0.20 to 0.29N m
Model Applicable wire size
2
0.088 to 0.3mm
Use cables with outside diameter of 1.3mm or shorter to
connect 40 cables to the connector.
0.088 to 0.24mm
28 AWG (stranded)
30 AWG (solid)
Flat cable of 1.27mm pitch
2
0.088 to 0.3mm
Use cables with outside diameter of 1.3mm or shorter to
connect 40 cables to the connector.
FUJITSU COMPONENT LIMITED
www.fcl.fujitsu.com/en/
(28 to 22 AWG) (stranded)
2
(28 to 24 AWG) (stranded)
(28 to 22 AWG) (stranded)
Contact
4
111