Bus Connection Of Got - Mitsubishi Electric Q26UD(E)HCPU User Manual

2.3.1

Bus connection of GOT

In the system with the Q series CPU module, the GOT can be bus-connected using the extension cable connector of
the main base unit or extension base unit.
This section describes the system configuration when a GOT is bus-connected to the CPU module.
For details of bus-connection of GOT, refer to the following.
GOT-A900 Series User's Manual (Connection)
GOT1000 Series Connection Manual (Mitsubishi Products) for GT Works3
GOT2000 Series Connection Manual (Mitsubishi Products) For GT Works3 Version1
(1) GOT recognized by CPU module
When a GOT is bus-connected, the CPU module recognizes the GOT as an intelligent function module with 16
I/O points.
For this reason, the I/O numbers must be assigned to the CPU module in the GOT setup.
(When bus-connecting a GOT, one extension level (16 points x 10 slots) must be occupied.)
For details of the GOT setup, refer to the following.
GOT-A900 Series Operating Manual (Extension Function /Option Function)
GT15 User's Manual
GT16 User's Manual (Basic Utility)
(2) Maximum number of GOTs
Up to five GOTs can be bus-connected.
CHAPTER 2 SYSTEM CONFIGURATION
2
47