Mitsubishi Electric Q26UD(E)HCPU User Manual page 206

Item
Mounting position
Applicable base unit
Input power supply
Input frequency
Input voltage distortion
factor
Max. input apparent
power
*1
Inrush current
5VDC
Rated output
current
24VDC
Overcurrent 5VDC
*1
protection
24VDC
Overvoltage 5VDC
*1
protection 24VDC
Efficiency
Allowable momentary
*1
power failure time
Dielectric withstand
voltage
Insulation resistance
• By noise simulator of 1500Vp-p noise voltage, 1µs noise width and 25 to 60Hz noise frequency
Noise durability
• Noise voltage IEC 61000-4-4, 2kV
Operation indication
Fuse
Application
Rated switching
voltage, current
Minimum
switching load
Response time
Life
Surge
suppressor
Fuse
Terminal screw size
Applicable wire size
Applicable solderless
terminal
Applicable tightening
torque
204
Q64RPN
+10%
100 to 240VAC
-15%
(85 to 264VAC)
Within 5% (
70% or more
2300VAC per minute (altitude 0 to 2000m)
Between the combined "line input/LG terminals" and the "FG terminal and output"
10MΩ or higher by 500VDC insulation resistance tester
Between the combined "line input/LG terminals" and the "FG terminal and output", the line input and
LG terminals, the output and FG terminals
LED indication (Normal: ON (green), Error: ON (red))
ERR. contact (
OFF to ON: 10ms max. ON to OFF: 12ms max.
Electrical : More than 100 thousand times at rated switching voltage, current
R1.25-3.5, R2-3.5, RAV1.25-3.5, RAV2-3.5
Performance Specifications
Power supply module mounting slot
Q3RB, Q6RB, Q6WRB
50/60Hz ±5%
Page 103, Section 4.8.1)
160VA
20A within 8ms
8.5A
----
9.35A or more
----
5.5 to 6.5V
----
Within 20ms
Built-in (User-unchangeable)
Page 188, Section 7.1)
24VDC, 0.5A
5VDC, 1mA
Mechanical : More than 20 million times
None
None
M3.5 screw
2
0.75 to 2mm
0.66 to 0.89N•m
Q64RP
*3
100 to 120VAC/200 to 240VAC
(85 to 132VAC/170 to 264VAC)
65% or more
*2*4
+10%
-15%