Operation For Removing Or Replacing An Sd Memory Card - Mitsubishi Electric MELSEC iQ-R Series User Manual

Operation for removing or replacing an SD memory card

Make sure to stop the file access by following the procedure as shown below when removing or replacing an SD memory
card.
If the power is OFF and the file access is not stopped, turn the power ON and stop the file access.
Stop file access and disable reading/writing
to the SD memory card.*1
Remove the SD memory card.*2
Insert an SD memory card to replace.*3
Turn the power OFF to ON.
*1 Page 43 File access stop processing method
*2 Page 44 Removal procedure
*3 Page 44 Insertion procedure
• If an error occurs on an SD memory card, refer to the following:
(MELSEC iQ-R OPC UA Server Module User's Manual (Application))
• The setting of an OPC UA server module is saved in an SD memory card. Therefore, if the CPU module is
turned OFF to ON or reset when any SD memory card is inserted or any setting is not written to the SD
memory card, the IP address of the OPC UA server module returns to the default (192.168.3.3).
As necessary, read the current setting before removing an SD memory card. Then, promptly write the
setting to the new card after the replacement.
4 PROCEDURE BEFORE OPERATION
42
4.4 SD Memory Card
Start
Is the power ON?
YES
Do you want to replace
the SD memory card?
YES
Update the setting.
Reset the CPU module.
Finish
NO
Turn the power of the programmable controller ON.
NO