Handling - Mitsubishi Electric Q26UD(E)HCPU User Manual

9.3

Handling

(1) Formatting a memory card
An SRAM or ATA card must have been formatted to be installed to the CPU module.
Since the SRAM or ATA card purchased is not yet formatted, format it using a programming tool before use.
(Formatting is not necessary for Flash cards.)
For formatting, refer to the following.
Operating manual for the programming tool used
Do not format an ATA card other than by the programming tool.
(If formatted using format function of Microsoft
module.)
(2) Installing a battery to an SRAM card
A battery used to backup for power failure is supplied with the SRAM card.
Before using the SRAM card, install the battery.
Note that the SRAM card memory is not backed up by the CPU module battery only.
Also, the program memory, standard RAM, and latch devices of the CPU module are not backed up by the battery installed
on the SRAM card.
(3) Storable files
For the files that can be stored on each memory card, refer to the following.
Manuals for the CPU module used (Function Explanation, Program Fundamentals)
(4) Precautions for installing/removing a memory card during power-on
Note that the data in a memory card may be damaged if the procedures described in Page 97, Section 4.5 (3) and
Page 97, Section 4.5 (4) are not followed. If the operating status of the CPU module at the time of an error is set
to "Stop" in parameter, the CPU module stops its operation upon the occurrence of "ICM.OPE.ERROR".
240
® ®
Windows Operating System, the ATA card may not be usable in a CPU