Mitsubishi Electric Q26UD(E)HCPU User Manual page 155

Item
Program memory
Memory card (RAM)
Flash
Memory
Max. number
card
card
of files stored
(ROM)
ATA card
Standard RAM
Standard ROM
Initial
Max. number of intelligent
setting
function module
parameters
Refresh
No. of times of writing data into the
standard ROM
No. of I/O device points
(No. of points usable on program.)
No. of I/O points
(No. of points accessible to the actual
I/O module.)
Internal relay [M]
Latch relay [L]
Link relay [B]
Timer [T]
Retentive timer [ST]
Counter [C]
Data register [D]
Link register [W]
Annunciator [F]
Edge relay [V]
*4 The CPU module can execute up to 124 programs. Any program exceeding 124 cannot be executed.
*5 The number has been increased by the function upgrade of the CPU module.
( Qn(H)/QnPH/QnPRHCPU User's Manual (Function Explanation, Program Fundamentals))
*6 The number of points can be changed within the setting range.
( Qn(H)/QnPH/QnPRHCPU User's Manual (Function Explanation, Program Fundamentals))
*11 When the Q2MEM-2MBS is used, the maximum number of files stored is 287 for the CPU module whose serial number
(first five digits) is "16020" or earlier.
Q02PHCPU Q06PHCPU
28
319 (When the Q3MEM-4MBS is used)
28
8192 points by default (M0 to 8191) (changeable)
8192 points by default (L0 to 8191) (changeable)
8192 points by default (B0 to 1FFF) (changeable)
2048 points by default (T0 to 2047) (sharing of low- and high-speed timers) (changeable)
The low- and high-speed timers are specified by the instructions.
The measurement unit of the low- and high-speed timers is set up by parameters.
(Low-speed timer: 1 to 1000ms, 1ms unit, 100ms by default)
(High-speed timer: 0.1 to 100.0ms, 0.1ms unit, 10.0ms by default)
0 point by default (sharing of low- and high-speed retentive timers) (changeable)
The low- and high-speed retentive timers are specified by the instructions.
The measurement unit of the low- and high-speed retentive timers is set up by parameters.
(Low-speed retentive timer: 1 to 1000ms, 1ms unit, 100ms by default)
(High-speed retentive timer: 0.1 to 100.0ms, 0.1ms unit, 10.0ms by default)
Normal counter, 1024 points by default (C0 to 1023) (changeable)
Interrupt counter: 256 points max. (0 points by default, setting by parameters)
12288 points by default (D0 to 12287) (changeable)
8192 points by default (W0 to 1FFF) (changeable)
2048 points by default (F0 to 2047) (changeable)
2048 points by default (V0 to 2047) (changeable)
Process CPU
Q12PHCPU
60 124
288
512
*5
3
60 124
512
256
Max. 100000 times
8192 points (X/Y0 to 1FFF)
4096 points (X/Y0 to FFF)
CHAPTER 6 CPU MODULE
Q25PHCPU
*4
252
*11
252
153
6