Mitsubishi Electric Q26UD(E)HCPU User Manual page 69

• For Q00JCPU, Q00UJCPU, Q33B, Q35B, Q35DB, Q65B, Q52B, Q55B, Q63B, Q32SB, Q33SB or Q35SB
type
Screw the DIN rail in two places using the mounting screws and square washers included with the
adaptors in 'Position A' (bottom of base unit).
B *3
Mounting screws
(included with adaptors)
DIN rail
Square washers necessary*1
35mm
Stopper
*1 The following shows where to position the square washers.
Square washer
Mounting screws
(M5 10)
*2 Screw the DIN rail to a control panel using the mounting screws and square washers included with the adaptors in
'Position A' (bottom of base unit).
*3 Screw the DIN rail with mounting screws(obtained by user) in 'Position B' (Where the base unit is not installed). In this
method the supplied mounting screws and square washers are not used.
● Use only one washer for each mounting screw. Use only the square washers supplied with the adaptors.
If two or more washers are used together for one mounting screw, the screw may interfere with the base unit.
● Make sure to align the square washer sides with the DIN rail.
square washer
● Use the DIN rail that is compatible with M5 size screws.
A *2
Mounting screws (obtained by user)
No square washers
Stopper
P P
DIN rail
Side view A
DIN rail
CHAPTER 4 INSTALLATION AND WIRING
B *3
P
P=200mm or less
Mounting screws DIN rail
Mounting side
square washer
(e.g. Control panel)
Side view A
square washer DIN rail
4
67