Resetting The System - Edge-Core ECS4510-28P User Manual

R S
ESETTING THE YSTEM
W I
EB NTERFACE
To display memory utilization:
Click System, then Memory Status.
1.
Figure 24: Displaying Memory Utilization
Use the System > Reset menu to restart the switch immediately, at a
specified time, after a specified delay, or at a periodic interval.
CLI R
EFERENCES
◆ "reload (Privileged Exec)" on page 710
"reload (Global Configuration)" on page 706
◆
"show reload" on page 711
◆
C U
OMMAND SAGE
This command resets the entire system.
◆
When the system is restarted, it will always run the Power-On Self-Test.
◆
It will also retain all configuration information stored in non-volatile
memory by the copy running-config startup-config
"copy" on page 734).
P
ARAMETERS
The following parameters are displayed:
System Reload Information
Reload Settings – Displays information on the next scheduled reload
◆
and selected reload mode as shown in the following example:
"The switch will be rebooted at March 9 12:00:00 2012. Remaining
Time: 0 days, 2 hours, 46 minutes, 5 seconds.
Reloading switch regularly time: 12:00 everyday."
Refresh – Refreshes reload information. Changes made through the
◆
console or to system time may need to be refreshed to display the
current settings.
Cancel – Cancels the current settings shown in this field.
◆
– 147 –
| Basic Management Tasks
C 4
HAPTER

Resetting the System

command (See