Resetting The System - Edge-Core ECS4810-12M Layer 2 Management Manual

R S
ESETTING THE YSTEM
W I
EB NTERFACE
To display memory utilization:
Click System, then Memory Status.
1.
Figure 19: Displaying Memory Utilization
Use the System > Reset menu to restart the switch immediately, at a
specified time, after a specified delay, or at a periodic interval.
CLI R
EFERENCES
"reload (Privileged Exec)" on page 592
◆
"reload (Global Configuration)" on page 588
◆
◆ "show reload" on page 593
C U
OMMAND SAGE
This command resets the entire system.
◆
When the system is restarted, it will always run the Power-On Self-Test.
◆
It will also retain all configuration information stored in non-volatile
memory by the copy running-config startup-config
"copy" on page 615).
P
ARAMETERS
The following parameters are displayed:
System Reload Configuration
Reset Mode – Restarts the switch immediately or at the specified
◆
time(s).
Immediately – Restarts the system immediately.
■
In – Specifies an interval after which to reload the switch.
■
(The specified time must be equal to or less than 24 days.)
hours – The number of hours, combined with the minutes,
■
before the switch resets. (Range: 0-576)
minutes – The number of minutes, combined with the hours,
■
before the switch resets. (Range: 0-59)
– 127 –
| Basic Management Tasks
C 4
HAPTER

Resetting the System

command (See