Lacp Port-Priority - Edge-Core AS6700-32X Cli Reference Manual

Default Setting
Actor: 1, Partner: 0
Command Mode
Interface Configuration (Ethernet)
Command Usage
◆
◆
◆
Note:
operation. The local switch just records the partner admin-key for user reference.
◆
Example

lacp port-priority

This command configures LACP port priority. Use the no form to restore the default
setting.
Syntax
Default Setting
32768
Ports are only allowed to join the same LAG if (1) the LACP system priority
matches, (2) the LACP port admin key matches, and (3) the LACP port channel
key matches (if configured).
If the port channel admin key
channel group is formed (i.e., it has the null value of 0), this key is set to the
same value as the port admin key (lacp admin key - Ethernet Interface) used
by the interfaces that joined the group.
Once the remote side of a link has been established, LACP operational settings
are already in use on that side. Configuring LACP settings for the partner only
applies to its administrative state, not its operational state.
Configuring the partner admin-key does not affect remote or local switch
By default, the actor's operational key is determined by port's link speed
(1000f - 4, 100f - 3, 10f - 2), and copied to the admin key.
Console(config)#interface ethernet 1/5
Console(config-if)#lacp actor admin-key 120
Console(config-if)#
lacp {actor | partner} port-priority priority
no lacp {actor | partner} port-priority
actor - The local side an aggregate link.
partner - The remote side of an aggregate link.
priority - LACP port priority is used to select a backup link. (Range: 0-65535)
– 395 –
Chapter 11
| Link Aggregation Commands
Dynamic Configuration Commands
(lacp admin key - Port Channel) is not set when a