Viewing Captured Data; Configuration; Port Status; Statistical Reports - LeCroy Sierra M6-2 User Manual

LeCroy Corporation

Viewing Captured Data

After data capture, the captured data is in the Viewer
page
You can show or hide fields and ports, change port names, and change data format.
You can show the layers and channels using their toolbars.
You can decode using the Decode toolbar.
You can Search and Filter.

Configuration

For special work, you can use the Configuration menu to configure Data Blocks, Software
Settings, and TxVout & Pre‐emphasis

Port Status

You can display an overview of the active ports by clicking the buttons at the bottom right
of the main window

Statistical Reports

You can generate statistics for all transports, commands, primitives, bus conditions,
addresses, lanes, and errors

Data Report

The data report displays all the data sent from the host to the device and from the device
to the host

InFusion

The LeCroy InFusion™ Error Injector and Traffic Modifier is an error injector and traffic
modification tool that allows you to verify real‐world fault handling for
Serial Attached SCSI (SAS) and Serial ATA (SATA) systems
page
38
191). You can display the same data in:
Packet View: Shows packets.

Text View: Shows transaction frames, grouped in columns by port.

Column View: Shows DWORDs in columns by port.

Spreadsheet View: Shows Packet View fields by time.

Histogram View: Shows frame‐type transfers.

Waveform Display: Shows waveform display for all active ports, on which you

can perform timing measurements.
Data View: Displays data payloads.

(See "Port Status" on page
(See "Data Report" on page
313).
(See "Display Configuration" on page
214).
(See "Statistical Report" on page
293).
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Viewing Captured Data
(See "Display Manipulation" on
244).
270).
(See "InFusion Overview" on