LeCroy Corporation
Select Device
After you start the software, click on Configuration and select All Connected Devices (see
the following screen capture).
Figure 1.11: Connecting to All SAS Device(s)
Figure 1.12: Connecting to All SATA Device(s)
The Select Device dialog allows connecting and disconnecting analyzers on the fly,
without restarting the application.
However, this requires updating the firmware component in the analyzer over USB, as the
previous firmware will not report any analyzer connected over Ethernet to Software
versions 4.10 and later.
26
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Expandability