LeCroy Sierra M6-2 User Manual page 148

LeCroy Corporation
Host Emulator
You can run an Host Emulator while setting:
Check Autostop exerciser when Analyzer Stopped to halt the Host Emulator when the
Analyzer stops.
Check CONT Usage to enable the specification of Delay between getting HOLD to
sending HOLDA, Data Frame Payload Size, and ATA Command Execution Timeout.
ATA Command Execution Timeout
The ATA Command Execution Timeout is a timeout for ATA commands. When the host
sends an H2D frame (i.e., it issues a command) and receives an R_OK from the device, it
starts this timer. If the execution of the command takes more than the timeout specified
(15 seconds is the default), the host emulator performs the action specified in the
Advanced/General/ ATA command timeout recovery action settings. The options are
Nothing, Send Soft Reset and Hard Reset.
Queue Settings
Click the Queue Settings button to display the Queue Settings dialog and specify:
Figure 2.148: SATA: Queue Settings Dialog
146
Auto stop exerciser when Analyzer stops

CONT usage

Delay between getting HOLD to Sending HOLDA

Data Frame Payload Size

ATA Command Execution Timeout

Logical Block Size (for ATAPI)

Queue Depth

NCQ Error Recovery

Queued/Non‐Queued Items Status

NCQ/Queue Command Timeout

S ierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Exercise and Capture