Table of Contents
Advertisement
Exercise and Capture
Sample Initiator Emulator Program (SAS only)
Figure 2.115 shows a simple completed SAS Initiator Emulator program.
Figure 2.115: SAS: Sample Initiator Emulator Program
Data Blocks
For commands requiring data blocks, click the down arrow of the
Payload Data drop‐down combo box and choose from a set of pre‐defined data blocks. If
you need a new data block, select Configuration > Data Block or click the
icon on the tool bar to open a data block definition dialog
page 150.
Exercising Specific Addresses
Since more than one device can be active at any given time, you can specify specific
commands to send to an address. To assign commands to an address:
1. Click the down arrow on a Target SAS Address block in a completed
Cursor
Figure 2.116: SAS: Find SAS Devices Select
S ierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Option button
for instructions on creating data blocks).
Initiator Emulator program, then choose Find New Device.
Find New Device
LeCroy Corporation
Data Block
(See "Creating a Data Block" on
123
Advertisement
Table of Contents
