Using The Power Expansion Card - LeCroy Sierra M6-2 User Manual

Tools
The Link Layer has Link Reset, Connections, SSP Frames,
Closing SSP Connections, Connections through Expanders, and Break.
The Transport Layer has SSP Frames Structures, Command IU, Data IU,
XFER_RDY IU, Response IU, and Error Handling.
The Application Layer has SCSI CDB and STP Operations.
2. Choose the tests in the left pane of the dialog and click the Add>> button.
3. Enter a value for DUT Type: Target, Initiator, or Expander.
4. Enter the DUT Name.
5. Enter the Connection Rate as Autospeed or a value.
6. To view failed test traces in the sample viewer, check the
7. To save the failed test traces only, check the Save only failed test traces check box.
8. Enter a path and file name for Report file, or use the default file name and path: 
9. Enter a path and file name for Saved Traces, or use the default folder: 
10. After you select tests, click Start.
11. The test runs and, after a brief period, displays the result.
12. To save the current compliance setup for later use, click the Save button to open the
13. To run a previously defined setup, click the Load button and choose a previously
For the NACA test, both ports of the SAS device must be connected to two Host Emulation
ports, I1 and I2, using two SATA cables.
Note:
When you are running SAS Verification, you cannot work with Trainer and Emulator while device
is connected to D connector and HBA is connected to H connector.

Using the Power Expansion Card

You can use the Power Expansion Card for SAS Verification. See
Expansion Card" on page
S ierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Automatically load failed test traces into STX trace viewer check box.
c:\program files\lecroy\sas protocol suite\User\SASVerification_Device1.rtf
C:\Program Files\LeCroy\SAS Protocol Suite\User\
Save As dialog. Assign a meaningful name to the setup and save it as a *.cst
compliance file.
defined setup to run.
30.
LeCroy Corporation
"Using the Power
307