Table of Contents
Advertisement
LeCroy Corporation
3. Connect the OUT Clock connector of Unit 1 to the IN Clock connector of Unit 2 using
4. Connect the OUT 10‐pin connector of Unit 1 to the IN 10‐pin connector of Unit 2
Note:
Unit 1 must be the unit that has the first out connection.
Figure 1.7: Cascading
Figure 1.8: Cascading Correctly
24
the supplied stacking cables. Similarly connect any additional units.
using the supplied stacking cables. Similarly connect any additional units.
Correct way to connect:
The black color pin of the
ribbon wire is connected
the same way between
2 connectors.
Cascading works correctly
in this case.
Black color pin
of ribbon wire
Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Expandability
Advertisement
Table of Contents
