Exercise and Capture
Adding Initiator or Host Emulator Commands
Adding an ATA Command
Click the Insert ATA Command button, click one of the command categories, and choose
a command.
Figure 2.89: ATA Dropdown List
The following menu options are available:
Smart Commands (SATA only)
To enable smart commands, click the Settings tab to open the Settings dialog, click the
Advanced button to open the Advanced Target Setting dialog, go to the Miscellaneous
Feature tab, check Support smart feature set, and check the specific features to enable
them (see
Note about Payload Data file: The software refreshes the Payload Data file
automatrically, so when you select a Payload Data file, you get the latest version.
For the SPC4 SEND DIAGNOSTIC command, if you have selected the non‐default path to
the development directory on the Software Settings page, that path is shown when you
select a Payload Data file.
S ierra M6‐2 SAS/SATA Protocol Analyzer User Manual
PIO In
PIO Out
DMA
DMA Queued
NCQ
ATAPI
Smart (see below)
Non‐Data
Others
User Defined
"Miscellaneous Features Tab" on page
188).
LeCroy Corporation
111