LeCroy Sierra M6-2 User Manual page 306

LeCroy Corporation
To run a Compliance Test:
1. Select Tools on the main toolbar and choose Compliance Test to open the
Figure 3.144: SATA: Compliance Test Selection
The Digital Test Group has:
The PHY Test Group has tests OOB‐03 through OOB‐07.
2. Choose the tests in the left pane of the dialog and click the Add>> button.
3. Enter a value for Capture Timeout.
Note:
If test running time exceeds the Capture Timeout value, the test terminates.
4. Enter the Device Name.
304
Compliance Test dialog.
General Device Requirements: GTR‐01 through GTR‐05

Native Command Queuing: NCQ‐01 through NCQ‐05

Asynchronous Signal Recovery: ASR‐01 and ASR‐02

Software Settings Preservation: SSP‐01 through SSP‐12

Interface Power Management: IPM‐01 through IPM‐11

Digital Optional Features: DOF‐01 and DOF‐02

S ierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Tools