Connection Parameters - LeCroy Sierra M6-2 User Manual

Connection Parameters

Connection Parameters
To display the connection parameters, select Generate > Connect Parameters.
Figure 5.33: Connection Parameters Dialog
You can set the "Identify" frame parameter settings to keep the link connected:
You can select to not show the dialog until there is a generation mode change.
S ierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Device Type: End Device, Edge Expander, or Fanout Expander

SSP Initiator: Present or Not Present

STP Initiator: Present or Not Present

SMP Initiator: Present or Not Present

SSP Target: Present or Not Present

STP Target: Present or Not Present

SMP Target: Present or Not Present

SAS Address (hex): eight digits ‐ eight digits

PHY Identifier (hex): two digits

Zone Device: Yes or No

Zone Broadcast Method (hex): two digits

LeCroy Corporation
457