Selectable Filter Options For Sata - LeCroy Sierra M6-2 User Manual

Filtering
Use Pair SAS Addresses
You can use all available pair SAS addresses (Source ‐> Destination) instead of using SAS
source and destination addresses. To enable the pair SAS address filter option, check Use
Pair SAS Addresses check box in the Filter dialog.
Figure 3.54: SAS: SAS Address Filtering before and after Using Pair SAS Addresses
Note:
If you enable pair SAS addresses, the source/destination SAS addresses options are disabled and
filtering on them is ignored at filtering time. If you disable pair SAS addresses, the pair SAS
address option is disabled and filtering on it is ignored at filtering time.

Selectable Filter Options for SATA

The SATA filter options are:
S ierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Bus Condition

Incomplete Frames

FIS

ATA Command

Protocol Error

Port

ATAPI SCSI Command

Miscellaneous

Filter Idle

LeCroy Corporation
231