Pin-Outs For The Data In/Out Connector; Prototype Rework Area - LeCroy USB Protocol Suite Advisor T3 User Manual

USB Protocol Suite User Manual

2.10.1 Pin-Outs for the Data In/Out Connector

Table 1 lists the pin-out and signal descriptions for the Data In/Out connector on a cable
that connects to the Breakout Board.
Table 1
Pin
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
Note:

2.10.2 Prototype Rework Area

The Breakout Board contains a prototype rework area for making custom circuits for rapid
development. The area consists of plated-through holes, 20 columns wide by 27 rows
long. The top row of holes connects to GND, and the bottom row connects to +5 V. The
remaining holes are not connected. Use the rework area to insert custom components
and wire-wrap their respective signal, power, and ground pins.
LeCroy Corporation
Data In/Out Connector – Pin-Out
Signal Name Signal Description
RSV Reserved
GND Ground
GP OUT General Purpose Output
TRG IN 1 Trigger In 1
GND Ground
DATA 6 Data 6
DATA 4 Data 4
DATA 3 Data 3
DATA 1 Data 1
GND Ground
RSV Reserved
RSV Reserved
+5V +5 Volts, 250 mA DC Source
RSV Reserved
GND Ground
TRG OUT Trigger Out
TRG IN 0 Trigger In 0
DATA 7 Data 7
DATA 5 Data 5
GND Ground
Pins 4 and 17 have the same function. They allow external signals to be
(*)
used to cause triggering or recording. Pins 3 and 16 are used to transmit
output signals.
Chapter 2: General Description
39