Time Out Of Ata Command Report; Atapi Report - LeCroy Sierra M6-2 User Manual

LeCroy Corporation
Figure 3.102: SATA: ATA Command Report

Time out of ATA Command Report

The Time out shows the NCQ time out. It is applicable for only NCQ commands. A
threshold can be set in the "NCQ commands Timeout Threshold", the default value is
1000 sec (the user can change it to any value). The statistical report provides a "Time
out" report based on this threshold. Any NCQ command that takes more than the given
threshold is flagged as "yes", which means that a timeout occurred for that command.

ATAPI Report

To display the ATAPI Report, click the ATAPI tab. The ATAPI Report displays information in
the following columns:
Figure 3.103: SATA: ATAPI Report
274
%: of total count

Command: All, Custom, Inquiry, Mode Sense 10, Read10, Request Sense

Direction: All, H‐>D, D‐>H, or Custom

Number of FIS or Number of Transport: All, Custom, or a number

Payload Size: All, Custom, or a number of DWORDs

Status: All, Custom, Check Condition, Good

Duration: All, Custom, or time unit (accumulative)

Count: All, Custom, or a number of occurrences

%: of total count

S ierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Statistical Report Content