Table of Contents
Advertisement
LeCroy Corporation
Figure 2.166: SAS: Target Emulation Project Pages Tab
The Target Emulator pages open with default settings for each page. To change settings
for your application:
1. Select a page in the Supported Pages box and set values for each of the enabled
2. Enter values for Density Code, Medium Type, and Device Specific Parameter for the
3. Check SSP or SMP to specify the protocol to support.
4. To reset the pages to the default settings, click the Default Settings button.
5. To use a previously defined Target, click the Import button and choose a previously
Note:
Clicking the Import button on any of the Target Emulation dialogs sets all the parameters for the
current emulation, including User‐Defined Commands.
SATA: To set up a Device Emulation, click File > New > Device Emulator.
The Device Emulation project opens with the Pages tab selected.
162
(white) Value fields.
target emulator.
defined Device Identifier *.saf file.
Target and Device Emulation
S ierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Advertisement
Table of Contents
