Table of Contents
Advertisement
LeCroy Corporation
336
TABLE 4.3: Test State Actions
Action
Beep
Branch to Existing State
1
New State
Capture Data DWORD
Inject
CRC Error
Invalid 10bit‐code
Error
Running Disparity
Error
Insert
Address Frame
FIS Frame
SAS Primitive
SMP Frame
SSP Frame
Insert DWORD
Link
Disconnect
Reconnect
Monitor/Count
Remove
Frame Partially
Primitive
Whole Frame
Restart
All Sequences
Current Sequence
SNW
Speed Negotiation
Retime
Speed Negotiation
Violation
Stop Scenario
Substitute Data DWORD
with SAS Primitive Substitutes a SAS primitive in the traffic.
with SATA Primitive Substitutes a SATA primitive in the traffic.
Description
Emits audible sound of duration selectable via drop‐
down list.
Go to a state in this sequence that is already
1
1
defined.
Go to a state in this sequence that is not yet defined
(you need to define it).
Captures a data DWORD into one of four registers.
Injects a CRC error into the line.
Injects invalid 10b code into the line.
Injects a Running Disparity (RD) error into traffic.
Inserts a frame or primitive.
Inserts DWORD.
Puts both InFusion SAS ports at electrical idle
immediately.
Starts traffic pass‐through immediately. This action
restarts traffic after a previous disconnect command.
Once traffic is passing through, the initiator and
target resume OOB signaling.
Opens a window to count the number of events that
occur during a session. A session is a time interval
during which a scenario runs.
Removes the targeted event from the traffic.
1
Restart all sequences in the scenario.
1
Restart the sequence that contains this action
1
definition.
Set RCDT, SNTT, ALT/TLT, TX speed, TRAIN/
TRAIN_DONE pattern, and/or PHY Capability.
Set Violation Type.
Stops all scenario activity.
Substitutes a data DWORD in the traffic.
S ierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Scenario Actions
1
1
Advertisement
Table of Contents
