Table of Contents
Advertisement
LeCroy Corporation
SPEED_NEG_RCDT
SPEED_NEG_ALIGN0
SPEED_NEG_ALIGN1
Set Speed = LINK_SPEED_1_5G
Set Speed = LINK_SPEED_3G
Set Speed = LINK_SPEED_6G
Send_Phy_Capability
Send_Train_TrainDone
Delay (#)
Power_Expansion_On
Power_Expansion_Off
Exit (
414
)
ExitCode
Sierra Trainer Generation Commands
Generator will go through
SPEED_NEG_RCDT stage of SAS SpeedNeg
process using current SPEED_NEG_RCDT
settings.
Generator will go through
SPEED_NEG_ALIGN0 stage of SAS
SpeedNeg process using current
SPEED_NEG_ALIGN0 settings.
Generator will go through
SPEED_NEG_ALIGN1 stage of SAS
SpeedNeg process using current
SPEED_NEG_ALIGN1 settings.
Generator will change speed to 1.5G (if
MultiSpeed is enabled)
This settings is not applied
Advanced Connect is set.
Generator will change speed to 3G (if
MultiSpeed is enabled).
This settings is not applied
Advanced Connect is set.
Generator will change speed to 6G (if
MultiSpeed is enabled).
This settings is not applied
Advanced Connect is set.
Generator will send PHY Capability Bits.
(this command is used in SNW3).
Generator will send Train/Train Done
Patterns.
(This Command is used in Train Windows).
Generator will wait until # ns before
executing next command.
Switch on power expansion card.
Switch off power expansion card
Call this command in any branch of the
Trainer program to stop execution. After
exit, the Port Status dialog displays the exit
code.
Note: The Trainer GUI has LED indicators:
Green is for pass.
Red is for fail.
No color is for unknown or for user to
review.
S ierra M6‐2 SAS/SATA Protocol Analyzer User Manual
.
when
when
when
Advertisement
Table of Contents
