LeCroy Corporation
Notes Tab
Click the Notes tab and enter a Project Name and a brief description of the
Target Emulation project (see
Run Target Emulation
Click the
emulation.
Note:
You can run the analyzer while device emulation is active to monitor bus traffic.
Device Emulator Settings (SATA only)
Click the Settings tab to display the Device Emulator Settings dialog.
The Settings tab opens with a default set of values, which you can modify. To return to
these values, click the Default Settings button.
Figure 2.190: SATA: Device Emulator Settings
PHY/Link layer settings
Enter values for Align Transmission Period, Primitive Response Timeout, and Standby
Timeout, Device send Align Time and Delay between getting HOLD to Sending HOLDA
and specify a delay. Check CONT usage.
184
"Add a Project Note" on page
Activate Device button or select Project Setup > Active Device to start
Target and Device Emulation
100).
S ierra M6‐2 SAS/SATA Protocol Analyzer User Manual