Table of Contents
Advertisement
Exercise and Capture
Start Loop
Click the command at which to start the loop, and then insert the Loop Start instruction.
Figure 2.101: Start Loop
Loop Count
Enter the number of times to run the loop in the number text box, or click the down
arrow on the Count Drop‐down combo box and choose Infinite.
End Loop
Click the command at which to stop the loop, and then insert the Loop End instruction.
Figure 2.102: End Loop
Add a Goto
To insert an unconditional jump to a previously labeled command, insert a Goto
instruction. Then click the down arrow on the Drop‐down combo box and choose the
label to designate the destination command.
Figure 2.103: Goto
Add an If
To insert a conditional jump to a previously labeled command, insert an If instruction.
Choose a specialized condition for the If from the If flyout.
Figure 2.104: If
Then click the down arrow on the If Drop‐down combo box, choose the condition for the
jump and then the down arrow on the Goto Drop‐down combo box, and choose the label
to designate the destination of the jump.
Figure 2.105: If on Payload
S ierra M6‐2 SAS/SATA Protocol Analyzer User Manual
LeCroy Corporation
119
Advertisement
Table of Contents
