LeCroy Corporation
Figure 3.89: IP Setup Dialog
2. To change to Static IP, click the Static IP radio button.
Enter the Static IP Address.
Enter the Subnet Mask.
Click Update.
The system displays a warning message. Check your entries carefully.
If you do not enter correct data, the program will terminate.
Click Yes to get a success message.
Figure 3.90: SAS IP Setup Success Message
Click OK. The message closes and the device resets.
3. To change back to DHCP, in the IP setup dialog, click the DHCP radio button, then
266
click Update.
S ierra M6‐2 SAS/SATA Protocol Analyzer User Manual
USB IP Setup