Table of Contents
Advertisement
LeCroy Corporation
Setting
PauseTrnScrmblr.
ReconnectOnRun
AdvanceConnect
OutputOffAfterDC
AutoMode Settings
AutoOOBMode
AutoHoldMode
AutoDMAT
AutoHandshake
AutoSpeedNeg
AutoAlignSATA
AutoAlignSAS
430
Default
Value
Description
When set, the generator pauses the Idle scrambler of
0
Train/TrainDone pattern.
0
When "AdvanceConnect" and "ReconnectOnRun"
are set, the "Connect" command forces the Trainer
to disconnect the physical link before executing the
"Connect" command.
When "AdvanceConnect" is not set, this setting does
not affect the Trainer.
0
When set, the Trainer uses the
"PHY Capability" and "SupportSNW" settings,
instead of the "Set Speed" settings, for executing the
"Connect" command.
On
If set to On, Trainer puts DC Idle on line when it
detects sync lost on the link.
Off
On
When set, the generator will go through the stages of
bringing up the link automatically, including waiting
for and responding to the device or host it is
connected to.
0
When set, the generator will respond automatically
to Hold requests. Not supported for version 1.1
(reserved).
0
When set, the generator will respond automatically
to DMAT requests. Not supported for version 1.1
(reserved).
0
When set, the generator will respond automatically
to TBD commands. Not supported for version 1.1
(reserved).
On
When set, the generator will automatically go
throughthe speed negotiation process, for the speed
set in the PINTERFACEC_SERDES register for the
Trainer.
0
When set, the generator will automatically inserting
the stream 2 Align(0) primitives every 254
specified in the SATA spec.
On
When set, the generator will automatically inserting
the stream Align primitives every 2048
specified in the SAS spec.Two Align modes can be
turned on simultaneously, to support STP
Sierra Trainer Generation Commands
S ierra M6‐2 SAS/SATA Protocol Analyzer User Manual
s, as
DWORD
s, as
DWORD
Advertisement
Table of Contents
