Table of Contents
Advertisement
Sierra Trainer Generation Commands
Sierra Trainer Generation Commands
General Commands
IDLE (n)
CLEAR_CREDIT_AVAIL
RD_ERROR
CONNECT
DISCONNECT
PAUSE
OUTPUT_ON
OOB Commands
COMINIT
COMRESET
COMWAKE
COMSAS
SATA_ALIGN
SATA_D10_2
S ierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Generator will insert n idle
generation stream.
This commands clears the credit
established with the command
WF_CREDIT_AVAIL. (See WF_CREDIT_AVAIL
in following section on Wait Commands for
explanation).
Generator will insert one idle
the generation stream, which will
intentionally break RD sequence creating
RD error.
Generator will go through connection
sequence using current GenFile settings
(gen mode, speed, and so on). Generation
will not resume until connection is
established.
Generator will break existing connection to
DUT.
Generator will come to a break and the
user will be able to resume generation by
pressing Resume button on Generation
toolbar. Generator shall transmit idle
s while in the Pause.
DWORD
Takes the Trainer out of Electric Idle state. If
it is already out of Electric Idle, this is a
NOP.
Generator will send COMINIT OOB signals
using current COMINIT settings.
Generator will send COMRESET OOB signals
using current COMRESET settings.
Generator will send COMWAKE OOB signals
using current COMWAKE settings.
Generator will send COMSAS OOB signals
using current COMSAS settings.
Generator will go through SATA_ALIGN
stage of SATA SpeedNeg process using
current SATA_ALIGN settings.
Generator will go through SATA_D10_2
stage of SATA SpeedNeg process using
current SATA_D10_2 settings.
LeCroy Corporation
s into the
DWORD
into
DWORD
413
Advertisement
Table of Contents
