Resetting The Toolbar - LeCroy Sierra M6-2 User Manual

LeCroy Corporation

Resetting the Toolbar

The Analyzer Toolbar has the following:
The Generator Toolbar has the following:
From time to time (such as following a software upgrade), it is possible for the buttons on
the toolbar to not match their intended function. You can reset the toolbar by performing
the following steps:
1. Select View > Toolbars from the menu bar.
2. Select Customize from the submenu to display the Customize dialog box.
Figure 5.34: Customize Commands
458
Show InFusion Frame: Switches to InFusion frame.

Show Analyzer Frame: Switches to Analyzer frame.

Start Analyzer: Start Analyzer without switching to Analyzer frame.

Stop Analyzer: Stop Analyzer without switching to Analyzer frame.

Abort Analyzer: Abort Analyzer without switching to Analyzer frame.

Start Generation

Stop Generation

Resume Generation

Connect Link

Disconnect Link

Generation Options

S ierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Resetting the Toolbar