Infinitely Variable Change Of Numeric Data Value; Readout And Programming Of Indexed Parameters; How To Program On The Numerical Local Control Panel - Danfoss VLT AutomationDrive Programming Manual

How to Program
729RPM
Load depen. setting
1 - 60 Low speed load
compensation
1 0% 6
2.1.14 Infinitely Variable Change of
Numeric Data Value
If the chosen parameter represents a numeric data value,
◀
select a digit with the [ ] [
Change the selected digit infinitely variably with the [
▼
[ ] navigation keys.
The chosen digit is indicated by the cursor. Place the
cursor on the digit you want to save and press [OK].
957RPM
Start Adjustments
1-71 High starting torque time
0. s
4
2.1.15 Value, Step-by-Step
Certain parameters can be changed step by step or
infinitely varying. This applies to 1-20 Motor Power [kW],
1-22 Motor Voltage and 1-23 Motor Frequency.
The parameters are changed both as a group of numeric
data values and as numeric data values infinitely varying.
2.1.16 Readout and Programming of
Indexed Parameters
Parameters are indexed when placed in a rolling stack.
Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com
http://www.remotesiteproducts.com/p-20872-Danfoss-131H4490-VLT-Automation-VT-Drive-VFD-FC302-460V-25-HP.aspx
FC 300 Programming Guide
6.21A 1(1)
1- 6*
▶
] navigation keys.
▲
]
11.58A 1 (1)
1-7*
®
MG33MD22 - VLT is a registered Danfoss trademark
15-30 Fault Log: Error Code to 15-32 Alarm Log: Time contain
a fault log which can be read out. Choose a parameter,
▲ ▼
press [OK], and use the [ ] [
through the value log.
Use 3-10 Preset Reference as another example:
Choose the parameter, press [OK], and use the [
navigation keys to scroll through the indexed values. To
change the parameter value, select the indexed value and
press [OK]. Change the value by using the [
Press [OK] to accept the new setting. Press [CANCEL] to
abort. Press [Back] to leave the parameter.
2.1.17 How to Program on the Numerical
Local Control Panel
The following instructions are valid for the Numerical LCP
(LCP 101).
The control panel is divided into four functional groups:
1. Numerical display.
2. Menu keys and LEDs - changing parameters and
switching between display functions.
3. Navigation keys and LEDs (LEDs).
4. Operation keys and LEDs.
Display line: Status messages displaying icons and numeric
value.
LEDs
•
Green LED/On: Indicates if control section is on.
•
Yellow LED/Wrn.: Indicates a warning.
•
Flashing red LED/Alarm: Indicates an alarm.
] navigation keys to scroll
▲ ▼
] [ ]
▲ ▼
] [ ] keys.
2-9
2 2