Changing A Group Of Numeric Data Values; Infinitely Variable Change Of Numeric Data Value; Value, Step-By-Step; Read-Out And Programming Of Indexed Parameters - Danfoss VLT AQUA Drive FC 200 Programming Manual

How to Programme
2.2.12 Changing a Group of Numeric Data
Values
If the chosen parameter represents a numeric data value,
change the chosen data value by means of the [
navigation keys as well as the [
◀ ▶
[ ] [ ] keys to move the cursor horizontally.
113 RPM
Load depen. setting
1 - 60 Low speed load
compensation
100%
Illustration 2.13
▲ ▼
Press [ ] [ ] keys to change the data value. [
▼
the data value, and [ ] decreases the data value. Place the
cursor on the value to save and press [OK].
729RPM
Load depen. setting
1 - 60 Low speed load
compensation
1 0% 6
Illustration 2.14
2.2.13 Infinitely Variable Change of
Numeric Data Value
If the chosen parameter represents a numeric data value,
◀ ▶
select a digit with [ ] [ ].
635 RPM
Start Adjustments
1 - 71 Start Delay
00.0s
Illustration 2.15
Change the selected digit infinitely variably with [
The chosen digit is indicated by the cursor. Place the
cursor on the digit to save and press [OK].
®
VLT AQUA Drive Programming Guide
◀ ▶
] [ ]
▲ ▼
] [ ] navigation keys. Press
1.78 A 1(1)
1- 6*
▲
] increases
6.21A 1(1)
1- 6*
0.44 A 1 (1)
1- 7*
▲ ▼
] [ ].
®
MG20O602 - VLT is a registered Danfoss trademark
957RPM
Start Adjustments
1-71 High starting torque time
0. s 4
Illustration 2.16

2.2.14 Value, Step-by-Step

Certain parameters can be changed step by step or
infinitely varying. This applies to 1-20 Motor Power [kW],
1-22 Motor Voltage and 1-23 Motor Frequency.
The parameters are changed both as a group of numeric
data values and as numeric data values infinitely varying.
2.2.15 Read-out and Programming of
Indexed Parameters
Parameters are indexed when placed in a rolling stack.
15-30 Alarm Log: Error Code to 15-32 Alarm Log: Time
contain a fault log which can be read out. Choose a
parameter, press [OK], and use [
value log.
Use 3-10 Preset Reference as another example:
Choose the parameter, press [OK], and use [
through the indexed values. To change the parameter
value, select the indexed value and press [OK]. Change the
▲ ▼
value by pressing [ ] [ ]. Press [OK] to accept the new
setting. Press [Cancel] to abort. Press [Back] to leave the
parameter.
2.3 How to Programme on the Numerical
LCP
The following instructions are valid for the Numerical LCP
(LCP 101).
The control panel is divided into four functional groups:
1. Numerical display.
2. Menu keys and indicator lights - changing
parameters and switching between display
functions.
3. Navigation keys and indicator lights (LEDs).
4. Operation keys and indicator lights (LEDs).
Display line: Status messages displaying icons and numeric
value.
11.58A 1 (1)
1-7*
▲ ▼
] [ ] to scroll through the
▲ ▼
] [ ] to scroll
19
2 2