Parameter Set-Up; Quick Menu Key Functions - Danfoss VLT AutomationDrive Programming Manual

How to Program
Operating variable:
16-85 FC Port CTW 1
16-86 FC Port REF 1
16-90 Alarm Word
16-92 Warning Word
16-94 Ext. Status Word
Status screen I
This readout state is standard after start-up or initialization.
Use [INFO] to obtain information about the measurement
links to the displayed operating variables (1.1, 1.2, 1.3, 2
and 3).
See the operating variables shown in the screen below.
Status
799 RPM
1.1
1.2
Auto Remote Ramping
2
3
Status screen II
See the operating variables (1.1, 1.2, 1.3 and 2) shown in
the screen below.
In the example, Speed, Motor current, Motor power and
Frequency are selected as variables in the first and second.
Status
207RPM
1.1
Auto Remote Running
Status screen III
This state displays the event and action of the Smart Logic
Control. For further information, see section Smart Logic
Control.
Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com
http://www.remotesiteproducts.com/p-20872-Danfoss-131H4490-VLT-Automation-VT-Drive-VFD-FC302-460V-25-HP.aspx
FC 300 Programming Guide
Unit:
hex
hex
1 (1)
7.83 A 36.4 kW
0.000
53.2%
1.3
1 (1)
5.25A 24.4 kW
6.9Hz
1.3
1.2
2
®
MG33MD22 - VLT is a registered Danfoss trademark
Status
778 RPM
State: 0 o 0 (o )
When: -
Do: -
Auto Remote Running

2.1.6 Parameter Set-up

The Adjustable frequency drive can be used for practically
all assignments, which is why the number of parameters is
quite large. The Adjustable frequency drive offers a choice
between two programming modes - a Main Menu and a
Quick Menu mode.
The former provides access to all parameters. The latter
takes the user through a few parameters making it
possible to start operating the Adjustable frequency drive.
Regardless of the mode of programming, you can change
a parameter both in the main menu and quick menu
modes.

2.1.7 Quick Menu Key Functions

Pressing [Quick Menus] The list indicates the different
areas contained in the Quick menu.
Select My Personal Menu to display the chosen personal
parameters. These parameters are selected in 0-25 My
Personal Menu. Up to 20 different parameters can be
added in this menu.
Select Quick set-up to go through a limited amount of
parameters to get the motor running almost optimally. The
default setting for the other parameters considers the
desired control functions and the configuration of signal
inputs/outputs (control terminals).
Parameters are selected by using the arrow keys. The
parameters in the following table are accessible.
1 (1)
0.86 A 4.0 kW
2-5
2 2