I/O Options; Bus Controlled; Term 32/33 Pulses Per Revolution; Digital & Relay Bus Control - Danfoss VLT AutomationDrive Programming Manual

Parameter Descriptions
A
B
A
B

5-70 Term 32/33 Pulses per Revolution

Range: Function:
1024 [1 - 4096 ] Set the encoder pulses per revolution on the
*
motor shaft. Read the correct value from the
encoder.
This parameter cannot be adjusted while the
motor is running.
NOTE!
This parameter cannot be adjusted while the motor is
running.
Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com
http://www.remotesiteproducts.com/p-20872-Danfoss-131H4490-VLT-Automation-VT-Drive-VFD-FC302-460V-25-HP.aspx
FC 300 Programming Guide
CW
CCW
®
MG33MD22 - VLT is a registered Danfoss trademark
5-71 Term 32/33 Encoder Direction
Option: Function:
Change the detected encoder rotation
direction without changing the wiring to
the encoder.
[0] Clockwise Sets channel A 90° (electrical degrees)
*
behind channel B upon clockwise rotation
of the encoder shaft.
[1] Counter Sets channel A 90° (electrical degrees)
clockwise ahead of channel B upon clockwise
rotation of the encoder shaft.
NOTE!
This parameter cannot be adjusted while the motor is
running.

3.7.8 5-8* I/O Options

5-80 AHF Cap Reconnect Delay
Range: Function:
25 s [1 - 120 Guarantees a minimum off-time for the
*
s] capacitors. The timer starts once the AHF
capacitor disconnects and needs to expire
before the output is allowed to be on again. It
will only turn on again if the drive power is
between 20% and 30%.

3.7.9 5-9* Bus Controlled

This parameter group selects digital and relay outputs via
a serial communication bus setting.
5-90 Digital & Relay Bus Control
Range: Function:
0 [0 - 2147483647 ] This parameter holds the state of the
*
digital outputs and relays that is
controlled by bus.
A logical '1' indicates that the output is
high or active.
A logical '0' indicates that the output is
low or inactive.
3 3
3-67