Electrical Wiring - Control Cables - Danfoss VLT AutomationDrive Programming Manual

Introduction
1 1
The "protection mode" can be disabled by setting
14-26 Trip Delay at Inverter Fault to zero which means that
the Adjustable frequency drive will trip immediately if one
of the hardware limits is exceeded.

1.1.5 Electrical Wiring - Control Cables

Figure 1.1 Diagram showing all electrical terminals without options.
Terminal 37 is the input to be used for Safe Stop. For instructions on Safe Stop installation please, refer to the section Safe Stop Instal-
lation of the Design Guide.
* Terminal 37 is not included in FC 301 (Except FC 301 A1, which includes Safe Stop).
Terminal 29 and Relay 2, are not included in FC 301.
1-6
Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com
http://www.remotesiteproducts.com/p-20872-Danfoss-131H4490-VLT-Automation-VT-Drive-VFD-FC302-460V-25-HP.aspx
FC 300 Programming Guide
NOTE!
It is recommended to disable protection mode in hoisting
applications (14-26 Trip Delay at Inverter Fault = 0)
®
MG33MD22 - VLT is a registered Danfoss trademark