Baja WD250U Service Manual page 92

15. Installment
split pin 4x30 (1)
CAUTION:
After fastening the torque, the nut on the rear
axle is not allowed to be loose. If the nut con-
cave groove is not aligned with the splint hole
on the screw rod, align it by tightening up the
nut.
WARNING:
Always use the new splint pin
16. Installment
Right rear wheel (1)
Connecting nut of front and rear wheels (2)
Attached: The torque of the connecting nut of
front and rear wheels is 55Nm.
CAUTION:
The rotating direction of the wheel is the arrow
marking direction on the tire. For this, refer to
"Front wheel and Front Brake" section of this
chapter.
WARNING:
When installing the core nut to the rear wheel,
be sure to face its core edge to the wheel.
18. Installment
Connecting plate of rear wheel (1)
Washer 16 (2)
Rear wheel axle nut M16 (3)
Split pin 4x30 (4)
Left rear wheel (5)
Connecting nut of front and rear wheels (6)
Refer to "Rear wheel" section of this chapter.
19. Adjustment
Rear brake pedal clearance
Rear brake cable clearance
Refer to "Adjustment of left Lever and Rear
Brake Pedal Free Clearance" Section of chap-
ter 2.
Attached:
Rear brake pedal clearance: 20-30mm
Clearance of left lever center: 5.0-8.0mm
91