Baja WD250U Service Manual page 110

5. Take off nut (1) on the rear shock absorber,
bolt (2), rear shock absorber (3) .
6. Take off rear brake tension spring (1) .
7. Take off dusty cap on rear arm axle.
8. Check the free clearance of rear wheel fork
1
checking steps.
a: Check the torque value of rear arm joint bolt
and the torque value of rear arm bolt (2), and
nut of rear wheel fork right side.
Attached: Torque of rear arm joint bolt and nut
is 130N · m
Torque of rear arm joint nut (2) is 6N · m
b: Move the rear wheel fork across to check
2
the side clearance [A]. If the clearance is big,
check the relevant parts of bush bearing 30203
and frame.
Attached: Free clearance value is less than
1.00mm
c: Move the rear wheel fork up and down to
check the vertical clearance. If the clearance is
too tight, limited, or uneven, check the relevant
parts of bush bearing 30203 and frame.
109