Baja WD250U Service Manual page 182

30. Hand operated mechanism
1) Inspection
• Inspection (1)
If cracked, bent, or damaged, replace it.
• Driving jaw (2)
• Compressing Spring (3)
• Torsion spring (4) (Driving jaw position)
Wear/cracks/damage, replace it.
2) Inspection:
• Rolling spring (1) (Starting)
Wear/cracks/damage, replace it.
• Tension wire (2)
Wear/cracks/damage, replace it.
• Driving plate assy (3)
Cracks/damage, replace it.
31. Output Mechanism
1) Inspection
• All gears (1)
If pressing mark/abrasion/wear is found,
replace it.
• Connecting jaw (2)
If pressing mark/abrasion/wear is found,
replace it
• Driving shaft (3)
• Output shaft (4)
If damaged or bent, replace it.
CAUTION:
When replacing any gear or output shaft be
sure to readjust core gear washer, refer to
"Selection of adjusting washer" section.
2) Inspection
• Bearing (5)
If pressing mark or abrasion is found, replace
it.
3) Inspection
• Front joint and rear joint (1)
• Driving for (2)
• Needle bearing (3)
181