Baja WD250U Service Manual page 199

1
4
2
3
2
1
1. Reverse operation system
1) Mount:
• Reverse operation shaft (1)
• Operation plate (2)
• Reverse control lever (3)
• Circlip (4)
Mount the above on the rear driving cover.
2) Mount:
• Compressing spring (1) (on reverse gear
fork (4))
• Steel ball (2)
CAUTION:
Mount a positioning set pin into the fork first
for fixing the steel ball and spring, that is
easy to mount the fork pin into fork.
3) Lubrication:
Apply lubrication oil (SAE20W/40) in the
inner diameter of fork and pin.
4) Mount:
• Reverse gear fork shaft (1) (With
O-ring)
• Mount the reverse gear fork pin (1) into
the hole of rear driving cover (3)
• Reverse gear fork (2)
CAUTION:
• Mount the reverse fork shaft into the hole of
the reverse fork and then pull out the locating
pin and take it out.
• Check if the fork is working
198